Looking for a Lionel Body/Shell from a SD 40, 60, 70, 80, 90, that had a smoke unit. Need the exhaust insert from the shell, I melted mine and would like to replace. David

Same thing happened to my SD70 so I replaced it with brass detail parts and painted them to match the shell. Got them from P&D Hobbies. Under $10 and a little time and got a better look. I used the exhaust for a GP20 and some brass grill pieces that I cut to fit...Alot cheaper and easier than finding a shell..

Marty

Martin, just talked to Pat at P & D. He has a lot of parts you wouldn't hapen the part number you used for the exhaust stack? Thanks David.

I will check their site. Being as they are brass, probably under Cal Scale...

Marty

This link should take you to the right page for the exhaust stack. It is for a GP20 but looks good, is brass:
http://pdhobbyshop.com/show_products.php?category=Train..._category=Detailing% 20Parts&manufacturer=P%26amp%3BD

Marty

I forgot the part #'s. PDP 1008 and 1028. the 1028 are a set of louvers you can cut and trim and wedge into the stack to look like a grill. Paint them up and you can either just set it into the opening after removing the warped one and or you can glue it down with a drop or two of glue of your choice. Probably a small drop of Goo would work...

Marty

Thanks, Martin. I talked to Pat and ordered parts today. David